Archive | May, 2009

>see TXT ISLAND now on YouTube!

29 May

>

Advertisements

>TXT ISLAND : Featured by Shots

23 May

>
My short film ‘TXT Island’ is the front page item on Shots magazine website. For a treat this bank holiday weekend only, you can go over there to see the whole film!

>TXT ISLAND : The Trailer

19 May

>I know it’s a little bit indulgent to make a trailer for a film that’s only three and a half minutes long anyway, but I couldn’t resist it, could I? Click here to see the TXT Island trailer.

>The A to Z of TXT Island

17 May

>
Here’s a still of the plastic alphabet I used to make the film. I’ve got some titles and maybe another project in mind for these…

>’TXT Island’ wraps !!!

14 May

>TXT Island is finished !!! TXT Island is my stop-motion animated short film featuring animated letterforms; it’s made using those plastic pegboard signage panels you sometimes see in bars and cafes etc. The film is currently featured on the news page over at www.tandemfilms.com. There are a few stills and an extract of the film viewable there.
This blog will be updated with further news about the release as it happens…

>Nizo 4080 in Camera Hospital

13 May

>

This week on camera hospital, take a look at this fella… That’s right, it’s another German Braun Nizo, a younger one this time and would ya look at that gorgeous black coat… But he came in to the hospital with a dodgy trigger and couldn’t run anymore… We had to operate…


Well, it was touch and go for a while, and to be frank there were bits all over the place, but it’s good news. He’s back together again and whirring like a contented puppy… bet he can’t wait to go out and play…

>Sensors And Sensitivity

7 May

>Working late in the lab again! I’m trying to detect the film sprocket holes for my DIY cine film scanning project and in the process finding out quite a lot about photo-transistors. The plan is to mount one of these into my film transport mechanism to give feedback to the stepper motor. With some great support from Archie over at PC-control.co.uk I’ve made a little circuit to test the sensors and measure the high and low voltages they give.

By placing a bit of card or some white super8 film leader next to the sensors I had the circuit tuned quite well (using the salvaged Epson printer proximity sensor) to the point where I thought this to be a viable route… However, tests with actual film strips gave a very curious result… Though seemingly black to the naked eye, movie film seems to have little or no opacity when seen by the phototransistor.
Realising that the Epson photo diode/phototransistor device uses infrared light, I thought I’d take a look an infrared look at some movie film with my miniDV camera in nightshot mode…

Bingo! The cine film is pretty much transparent under IR lighting. There’s no way an IR photosensor will detect the sprocket holes when the film base itself is rendered almost completely transparent. I’ll be looking at sensors in the visible light range next…
(Also of interest here, notice how the film looks so scratched under IR lighting; some film scanners use just such an IR pass to enable infrared cleaning of scanned images.)